Thermal Imaging Survey in Lucan
Infrared surveys that show where your home loses heat, where insulation is missing, and where damp is likely. Covering Lucan village, Esker, Adamstown and the surrounding area.
Thermal Imaging Surveys for Lucan homes
Lucan's 1970s and 1980s estates are ideal for thermal imaging because the cavity walls show clearly whether they are empty, partly filled or full. A survey also picks out hollow-block houses, which lose heat evenly across the wall and need external insulation rather than a cavity fill, and shows attic insulation that has never been topped up. It is a quick, low-cost way to make sure the right upgrade is chosen before applying for grants.
How homes in Lucan lose heat
The 1970s and 1980s estates are the bulk of the housing and typically sit at C3 to D2, held back by empty or partly filled cavities, thin attic insulation and early glazing. Some earlier estate houses were built with hollow block rather than cavity walls, which need external insulation instead. Adamstown homes are newer and mainly benefit from airtightness checks.
Typical housing: Village terraces and pre-war semis near the centre, 1970s and 1980s estate housing through Esker and the middle of the town, and newer Adamstown developments.
How thermal imaging survey works
A thermal imaging camera reads the surface temperature of walls, ceilings, floors and windows. When there is a good temperature difference between inside and outside, heat escaping through a weak spot shows up clearly: a gap in attic insulation, an uninsulated lintel, a cold corner where condensation and mould tend to start, or a draught path around a window frame.
Thermal Imaging Survey in Lucan: questions
Do you carry out thermal imaging survey in Lucan?
Yes. We cover Lucan and the surrounding Dublin area, including Lucan village, Esker, Adamstown. Village terraces and pre-war semis near the centre, 1970s and 1980s estate housing through Esker and the middle of the town, and newer Adamstown developments.
Is there a grant for thermal imaging survey in Lucan?
There is no standalone SEAI grant for a thermal imaging survey. It is often the cheapest way to make sure grant-funded insulation goes where it does the most good. Grant amounts are set nationally by SEAI and change from time to time, so check seai.ie before applying. We confirm what your home is likely to qualify for during the survey.
When is the best time for a thermal imaging survey?
Thermal imaging needs a clear temperature difference between inside and outside, so the heating season from October to April gives the clearest results. Early morning or evening surveys avoid sunshine warming the walls.
Can a thermal camera see damp?
Damp areas often show as cooler patches because evaporation cools the surface, and cold surfaces are where condensation forms. The camera points to likely problem areas, which we then check with a moisture meter where needed.
Will it show whether my cavity wall insulation is complete?
Yes, gaps or settled areas in cavity fill usually show as warmer patches on the outside of the wall in winter, because more heat escapes through them. It is a quick way to check older fills.
Book a free survey in Lucan.
We cover Lucan and the surrounding area. Tell us about your home and we will arrange a visit, usually within a week.