Thermal Imaging Survey in Malahide
Infrared surveys that show where your home loses heat, where insulation is missing, and where damp is likely. Covering Malahide village, Malahide marina, Robswall and the surrounding area.
Thermal Imaging Surveys for Malahide homes
Thermal imaging in Malahide separates the two housing types quickly. Period homes near the village show whole-wall heat loss and draughts around sashes. The 1990s and 2000s estates usually show partial-fill cavities performing reasonably but with gaps at corners and around windows, plus thin patches in the attic. Owners preparing for a heat pump use the survey to confirm the house is ready.
How homes in Malahide lose heat
The period and pre-war homes lose heat through solid walls, suspended floors and sash windows, and the seafront ones are exposed to wind off the estuary. The 1990s and 2000s estates were built with partial-fill cavities and modest attic insulation; they usually rate C and respond well to attic top-ups, cavity checks and airtightness work.
Typical housing: Period stock around the village and marina, pre-war seafront semis, and 1990s and 2000s estate housing inland through Robswall and Yellow Walls.
How thermal imaging survey works
A thermal imaging camera reads the surface temperature of walls, ceilings, floors and windows. When there is a good temperature difference between inside and outside, heat escaping through a weak spot shows up clearly: a gap in attic insulation, an uninsulated lintel, a cold corner where condensation and mould tend to start, or a draught path around a window frame.
Thermal Imaging Survey in Malahide: questions
Do you carry out thermal imaging survey in Malahide?
Yes. We cover Malahide and the surrounding Dublin area, including Malahide village, Malahide marina, Robswall. Period stock around the village and marina, pre-war seafront semis, and 1990s and 2000s estate housing inland through Robswall and Yellow Walls.
Is there a grant for thermal imaging survey in Malahide?
There is no standalone SEAI grant for a thermal imaging survey. It is often the cheapest way to make sure grant-funded insulation goes where it does the most good. Grant amounts are set nationally by SEAI and change from time to time, so check seai.ie before applying. We confirm what your home is likely to qualify for during the survey.
When is the best time for a thermal imaging survey?
Thermal imaging needs a clear temperature difference between inside and outside, so the heating season from October to April gives the clearest results. Early morning or evening surveys avoid sunshine warming the walls.
Can a thermal camera see damp?
Damp areas often show as cooler patches because evaporation cools the surface, and cold surfaces are where condensation forms. The camera points to likely problem areas, which we then check with a moisture meter where needed.
Will it show whether my cavity wall insulation is complete?
Yes, gaps or settled areas in cavity fill usually show as warmer patches on the outside of the wall in winter, because more heat escapes through them. It is a quick way to check older fills.
Book a free survey in Malahide.
We cover Malahide and the surrounding area. Tell us about your home and we will arrange a visit, usually within a week.